Little more work done on this, and run into my first snag (minor one) and the fix for it.
Few more odds and ends fitted to the front compartment, seat frame and some stiffening bars
Rear blast shield on the bottom rear, tailgate and sides.
And here is the first minor hiccup, as you can see, 2 ejector pin marks on the top of the part, in very hard to reach areas (2 on the lower section already taken care of). So what to do?
Get yourself some skinny sanding sticks and cut off a couple of small parts of it.
Clamp the cut off piece of sanding stick into a set of locking tweezers, or something similar. Here I am using a pair of well used (notice the multiple layers of paint on them) hemostats.
And simply sand away the ejector pin marks. See, all gone.
So far up to this point, these have been the only seam or pin mark that would have been visible once assembly was finished. And so far fit has been perfect.
Here we see the panel in place.
Probably a little better than half way through assembly now, and nothing but good things to say about this kit.