Okay...here's one. Earlier this evening I was attempting to put a coat of Dunkelgelb on a panzer. i was using Tamiya Dk yellow, thinned about 60%paint 40% thinner, i'm not sure if this is the correct ratio but it's worked for me in the past.
I was painting in the garage, w/ a garage door partially open, outside temp about 70 degrees farenheit, and it's not real humid right now. But the interior of my garage is warmer than outside. My PSI is between 25- 30...
Now the problem, first i used my Testor's Aztec SA brush, I was getting plenty of air..but no paint. I used the same brush last nite, and it worked fine, cleaned it and put it away for tonite.
:-\
Then I tried my Master brush, it started out fine but then, it too would not pickup any paint.
In both cases the paint jar(?) was about 2/3 full. After dealing w/ frustration, I brought both inside for cleaning and to just walkaway. I was cleaning them in my basement, which is cooler than the garage, I ran some Rubbing alcohol thru both, and both picked up and sprayed fine.
What Gives???
I was painting in the garage, w/ a garage door partially open, outside temp about 70 degrees farenheit, and it's not real humid right now. But the interior of my garage is warmer than outside. My PSI is between 25- 30...
Now the problem, first i used my Testor's Aztec SA brush, I was getting plenty of air..but no paint. I used the same brush last nite, and it worked fine, cleaned it and put it away for tonite.
:-\
Then I tried my Master brush, it started out fine but then, it too would not pickup any paint.
In both cases the paint jar(?) was about 2/3 full. After dealing w/ frustration, I brought both inside for cleaning and to just walkaway. I was cleaning them in my basement, which is cooler than the garage, I ran some Rubbing alcohol thru both, and both picked up and sprayed fine.
What Gives???