Group Build: Biplane - barnstormer to fighter

[BarleyBop]

It may be a lot of effort but it sure looks a lot nicer.

We'll see how it works out with paint and all.
Every time I have a bit of brass, either PE or scratch, I'm tempted to leave it as is!

 

[kevin]

Every time I have a bit of brass, either PE or scratch, I'm tempted to leave it as is!

It sure looks pretty cool after the annealing........any manufacturer offering steampunk models?

 

[BarleyBop]

steampunk

Never looked, but must be! Would make great subject for scratch

 

[Edbert]

...speaking of flash...

Yep.....

Wow that's pretty bad. Honestly? How can QC release that? That's terrible

I think that is a result of old molds, they just do not seal up against each other. Once they reach that point there's nothing Quality Control can do and the cost of making new molds is really high.

 

[Edbert]

cleaned and annealed

Explain your process here please. I see marks that make me think there was an acid bath.

 

[BarleyBop]

Explain your process here please. I see marks that make me think there was an acid bath.

No acid here, just a sponge wipe with isopropyl, then quick heat with the mini torch.
I'm thinking I will lightly brush PE primer before priming the whole thing.

...learning as I go...

 

[Ron2]

I always hope for the best but brace for the worst, makes coming out somewhere in between more palatable. In the end, my experiment came out like a "Spaghetti Western" aka the Good the Bad and the Ugly. All of these pics are just after pulling up the tape, so no touch-ups yet.

Good
View attachment 197316

Bad
View attachment 197317
Ugly
View attachment 197318

But when I remember how bad the stickers looked, I'm fine with doing the repairs I'm about to embark on.

I always hope for the best but brace for the worst, makes coming out somewhere in between more palatable. In the end, my experiment came out like a "Spaghetti Western" aka the Good the Bad and the Ugly. All of these pics are just after pulling up the tape, so no touch-ups yet.

Good
View attachment 197316

Bad
View attachment 197317
Ugly
View attachment 197318

But when I remember how bad the stickers looked, I'm fine with doing the repairs I'm about to

... Well, at least we can't say RODEN isn't consistent!

Next step for the Gloster Sea Gladiator fuselage and wings is to try and integrate a set of hatches and latches from AIMS.

I'll just show the process for one.

• Scrape off the plastic details to fit the PE. (all new to me).
• Cleaned the PE up with alcohol,
• Lightly(?) annealed it with my mini torch.
• Because the PE is flat, the hatches need to be lightly scored on the back to produce the ribbing effect of the fuselage.

not scraped yet...

View attachment 197327

cleaned and annealed

View attachment 197328

scored from behind

View attachment 197329

view from the front, ready to be test fitted once the fuselage detail is removed

View attachment 197330

View attachment 197331


View attachment 197332

That is really an improvement!