Group Build: Biplane - barnstormer to fighter

[BarleyBop]

Gloster Sea Gladiator
So, finally looks like the pilot will have some dials and controls.

Still more to come from the Quinta Studio set, seat harness and such.

 

[kevin]

Those Quinta sets really pop!

I may have to add some aircraft kits to the stash I can try some myself.

 

[Tommergun]

Getting some more rigging done. It can be challenging but I think I figured out the basics. Lots of room for improvement though.

 

[Pantherman]

Getting some more rigging done. It can be challenging but I think I figured out the basics. Lots of room for improvement though.

View attachment 196982

I have started the rigging but so far have only managed the undercarriage wire's. Pantherman

 

[Bob T]

Getting close...I found the Roden decals a little....difficult? Worried about the really long ones down the side.

 

[kevin]

That red really looks good. What brand of paint did you use?

 

[Bob T]

That red really looks good. What brand of paint did you use?

Tamiya TS-85 Bright Mica Red in a rattle can.
I really tend to avoid spray cans, but it was the only option for this color.

 

[Edbert]

So, finally looks like the pilot will have some dials and controls.

That IP is fantastic!

I think even non-afficianados understand the leaps of technology that took place between the World Wars. But that Instrument Panel really shows the leaps that were made in the inter-war years.

Of course I know the Gladiator was technically a World War Eleven (Shout out to Senator Ilhan Omar!) aircraft, it was built well before hostilities broke out.

 

[BarleyBop]

That IP is fantastic!

Thanks. Credit to Quinta.
I didn't expect the extra gluing required for 'decals', but worked out okay.

Working on the harness straps...
They could've done a better job with instructions though, especially for an aircraft newb like me!

'A' is a Y shaped strap.
After lots of internet sleuthing, and some awesome drawings traced back to another British modeler site, turns out this is likely a 'Sutton harness' and the 'Y' gets glued on upside down and backwards so that it can be folded back (over the pilot's shoulders) and down his back to a hole in the seat back!

 

[Rockin' Rob]

Getting close...I found the Roden decals a little....difficult? Worried about the really long ones down the side.

I hope those long decals go on good because that plane is just screaming for some yellow pinstripes! That's looking good Bob t

 

[Edbert]

I didn't expect the extra gluing required for 'decals', but worked out okay.

It is a "thing" about the new normal of "3D decals". The weight far exceeds the adhesive :-)

But the results cannot be exceeded, I care not what horse you rode in here on!

 

[Rockin' Rob]

4 more wires to go. Then I'll clean up where they fit into the wing and make it look presentable. And believe me. I know on the ferry swordfish the wires were actually flat strap but once you mess up PE, games over.

 

[Tommergun]

Finished with the little 1/72 Gloster Gladiator. I noticed that I forgot to make new underwing guns since I had to cut the poorly molded muzzles off. I'll fix that later. I used EZ Line (fine) for the rigging. I learned next time to use a smaller drill bit than you think, you can always make the rigging hole bigger.

 

[Bear43]

I finally cracked open my kit and overall it's not horrible. There is considerable light flash but my biggest complaint are the big sink holes on the prop I will need to use. This kit is the Roden 1/48 Gloster Gladiator.

 

[Rockin' Rob]

Finished with the little 1/72 Gloster Gladiator. I noticed that I forgot to make new underwing guns since I had to cut the poorly molded muzzles off. I'll fix that later. I used EZ Line (fine) for the rigging. I learned next time to use a smaller drill bit than you think, you can always make the rigging hole bigger.

View attachment 197051
View attachment 197052
View attachment 197053

View attachment 197054
View attachment 197055

View attachment 197056

That looks pretty good for 172nd

 

[Edbert]

That is not "light" in my book!