Reply to thread

Message

So, last bits for the day...

As per the light kit instructions, I glued the pylons together. They were warped, but I used all my clamps on em for about an hour or two. Then once the glue was fairly set, I took the clamps off and checked for warpage. They were at this point only slightly warped, so I simply bent them slightly to get the warps out and now they are clamped to the bench to keep them flat till fully set up.[ATTACH=full]87723[/ATTACH]

I also have painted the insides of the shuttlebay doors, and will prime and paint the exteriors ar some point tomorrow along with the landing control room, then glue the open part of the doors and control room in place.

I installed the intermix bulbs on the reflector plates. I slightly changed it from what the instructions state by adding one small amber bulb and one clear one to each batch of the multicolor bulbs. The clear ones will be painted yellow.[ATTACH=full]87724[/ATTACH]

And the fans have final paint on em. Will brush on my brushable flat only on the fans themselves.[ATTACH=full]87725[/ATTACH]
[ATTACH=full]87726[/ATTACH]

<blockquote data-quote="Thereal9thdoctor" data-source="post: 208029" data-attributes="member: 20310">So, last bits for the day...As per the light kit instructions, I glued the pylons together. They were warped, but I used all my clamps on em for about an hour or two. Then once the glue was fairly set, I took the clamps off and checked for warpage. They were at this point only slightly warped, so I simply bent them slightly to get the warps out and now they are clamped to the bench to keep them flat till fully set up.[ATTACH=full]87723[/ATTACH]I also have painted the insides of the shuttlebay doors, and will prime and paint the exteriors ar some point tomorrow along with the landing control room, then glue the open part of the doors and control room in place.I installed the intermix bulbs on the reflector plates. I slightly changed it from what the instructions state by adding one small amber bulb and one clear one to each batch of the multicolor bulbs. The clear ones will be painted yellow.[ATTACH=full]87724[/ATTACH]And the fans have final paint on em. Will brush on my brushable flat only on the fans themselves.[ATTACH=full]87725[/ATTACH][ATTACH=full]87726[/ATTACH]</blockquote>

[QUOTE="Thereal9thdoctor, post: 208029, member: 20310"] So, last bits for the day... As per the light kit instructions, I glued the pylons together. They were warped, but I used all my clamps on em for about an hour or two. Then once the glue was fairly set, I took the clamps off and checked for warpage. They were at this point only slightly warped, so I simply bent them slightly to get the warps out and now they are clamped to the bench to keep them flat till fully set up.[ATTACH=full]87723[/ATTACH] I also have painted the insides of the shuttlebay doors, and will prime and paint the exteriors ar some point tomorrow along with the landing control room, then glue the open part of the doors and control room in place. I installed the intermix bulbs on the reflector plates. I slightly changed it from what the instructions state by adding one small amber bulb and one clear one to each batch of the multicolor bulbs. The clear ones will be painted yellow.[ATTACH=full]87724[/ATTACH] And the fans have final paint on em. Will brush on my brushable flat only on the fans themselves.[ATTACH=full]87725[/ATTACH] [ATTACH=full]87726[/ATTACH] [/QUOTE]

Verification