Fixing raised panel lines.

[Fork Virus]

Is there a way to fix raised panel lines after you sand them off?

 

[Junkie]

You can use stretched sprue.

or use masking tape, 2 pieces - one on each side of the panel line and then 'fill' in between the masking tape with putty. After it cures remove the tape and you'll have a raised line. It might need some work after the fact to get it to the same contour etc...as the molded panel lines.

 

[Fork Virus]

You can use stretched sprue.

or use masking tape, 2 pieces - one on each side of the panel line and then 'fill' in between the masking tape with putty. After it cures remove the tape and you'll have a raised line. It might need some work after the fact to get it to the same contour etc...as the molded panel lines.

Thank you! That was very helpful! ;D

 

[Dusky]

If you're like me and always fail miserably at stretching sprue, you can buy very thin styrene rod, either square or circular.