Strike Freedom Gundam: Lightning edition

Grendels

Active Member
Joined
Nov 24, 2009
Messages
9,079
Reaction score
9
Hello all Long time no post.

I am working on this; box.jpg


This is a large older Bandai kit. It is 1/60 scale. This is the same scale as a PG kit, but it lascks the details and inner frame of those kit.

My progress will be slow on this one. Lots of seams to be filled on the back pack.

Here is the review I did a while ago: Strike freedom review
 
Last edited:

Grendels

Active Member
Joined
Nov 24, 2009
Messages
9,079
Reaction score
9
Some progress has been made, the stand is done, but wiring was kind of difficult, especially since I was on a lot of drugs at the time just getting out of the hospital. If you carefully follow the directions, it won't be too bad.

20200720_175348.jpg

I used an older can of Testors spray paint and was a bit impatient. It bubbled. This was two weeks ago, it has cured up enough to start sanding out the bubbles. there isn't much detail, so it should be an easy fix.
 

Grendels

Active Member
Joined
Nov 24, 2009
Messages
9,079
Reaction score
9
The back pack is put together. I didn't force any of the parts together, so I can take it apart for seam filling and paint. The F91 gundam is for scale and is a MG kit.

20200720_175330.jpg
 

Quaralane

Well-Known Member
Joined
May 22, 2009
Messages
10,876
Reaction score
124
That back pack's huge, G

And good to see you back
 

Grendels

Active Member
Joined
Nov 24, 2009
Messages
9,079
Reaction score
9
Thanks, I will be very slow with this one.... Not like some of the gundam kits I can quickly snap together.
 

Latest posts

Top