Yup......LOL And thanks guys as always much appreciated!

I figured with the wells opened up i would start

to work on the rear boarding ramp and the back plate.

But first I decided i wanted to stop taping this thing

together all the time. So I drilled two holes and ran

some small screws and wing nuts to hold it all together.

[ATTACH=full]53043[/ATTACH]

[ATTACH=full]53044[/ATTACH]

[ATTACH=full]53045[/ATTACH]

This is the back plate it"s just in there loosy goosey

in the picture, the angle that the plate rests on down

inside the rear skirt, makes the landing ramp have to

come in further. I ended up a little short I should have waited

to make this. No matter I just made another one.

To short

[ATTACH=full]53046[/ATTACH]

This is the new one with the rear plate attached,

I made it so it can be removed and detailed later.

[ATTACH=full]53047[/ATTACH]

Just to protect the angle of the part I made up

a brace to fit over it on the unseen side.

[ATTACH=full]53048[/ATTACH]

Done...Still some sanding to do on that rear skirt.....been waiting to build a little

more strength into it.

[ATTACH=full]53049[/ATTACH]