Next bit of reality....I made the front skirt taller and wider than it

had to be....which is good but I didn't realize how much wider

until I stacked the parts today. That skirt has to match the profile

of the front of the fuselage, you can see how much it has to come

in on the sides. However I am not going to do that now, I am going

to form the two fuselage halves and then get them fitting clean, after

that I will place the formed fuselage up on the skirt buck. This will give

me the final profile shape to adjust via sanding. I have to take 3mm at

least off each formed half of the fuselage because they were built up on

3mm stock, then whatever after that to get them joining clean. Like I said

when they are together clean I will take that profile and pencil on the skirt

buck and adjust it then.

[ATTACH=full]50883[/ATTACH]