Reply to thread

Message

Thanks!!! And Grendels once again thanks for the info I will watch the heat and still have time to think the back lighting through.

Small update, but it's those little parts sometimes that you start working on and suddenly time goes right by so involved.. So I think I made what will house the front guns just need to dress them up a bit with more styrene and detail. The tubing/brass I hope will fit or I can accommodate with what the hobby shop has.

Here is the start of the new guns this way I can spend less time on them this weekend.

Just a tip, cause I have fought with bending styrene/card in the past and gluing it down.. what I did was glue one side of the rounded edge and held then glued the other side. I leaned this method from another modeler.. and it worked good. After letting go the styrene was glued on. I then sanded and cleaned up the seems.

Small update, but yet some work.

[ATTACH=full]51787[/ATTACH]

[ATTACH=full]51788[/ATTACH]

Keep on it..

Builder/Mike

<blockquote data-quote="builder101" data-source="post: 155279" data-attributes="member: 12289">Thanks!!! And Grendels once again thanks for the info I will watch the heat and still have time to think the back lighting through.Small update, but it&#039;s those little parts sometimes that you start working on and suddenly time goes right by so involved.. So I think I made what will house the front guns just need to dress them up a bit with more styrene and detail.&nbsp; The tubing/brass I hope will fit or I can accommodate with what the hobby shop has.&nbsp; Here is the start of the new guns this way I can spend less time on them this weekend. Just a tip, cause I have fought with bending styrene/card in the past and gluing it down.. what I did was glue one side of the rounded edge and held then glued the other side.&nbsp; I leaned this method from another modeler.. and it worked good.&nbsp; After letting go the styrene was glued on.&nbsp; I then sanded and cleaned up the seems. Small update, but yet some work.[ATTACH=full]51787[/ATTACH][ATTACH=full]51788[/ATTACH]Keep on it.. Builder/Mike</blockquote>

[QUOTE="builder101, post: 155279, member: 12289"] Thanks!!! And Grendels once again thanks for the info I will watch the heat and still have time to think the back lighting through. Small update, but it's those little parts sometimes that you start working on and suddenly time goes right by so involved.. So I think I made what will house the front guns just need to dress them up a bit with more styrene and detail. The tubing/brass I hope will fit or I can accommodate with what the hobby shop has. Here is the start of the new guns this way I can spend less time on them this weekend. Just a tip, cause I have fought with bending styrene/card in the past and gluing it down.. what I did was glue one side of the rounded edge and held then glued the other side. I leaned this method from another modeler.. and it worked good. After letting go the styrene was glued on. I then sanded and cleaned up the seems. Small update, but yet some work. [ATTACH=full]51787[/ATTACH] [ATTACH=full]51788[/ATTACH] Keep on it.. Builder/Mike [/QUOTE]

Verification