Reply to thread

Message

All the kind words help's keep the encouragement going, thanks.. I took a break from the scribing wing's today and cut out the floor for the cockpit and the back wall was scratchbuilt. I always remember the blue lights shining through the triangular shaped design in the back. I hope some of it is visible after I spray the cockpit glass a dark tint.. the glass right now in covered from dust after being dipped in future. I plan to run fiber to the cockpit and light behind the wall I built. Either styrene tube or brass run up along each side should light up the controls.

Here is some pic's of the start of scratching out the cockpit.

Thank's for for viewing.

Once again I scribed the top and once again it did not turn out.. Back to sanding.

Floor is cut to fit the bottom half.

[ATTACH=full]40622[/ATTACH]

Primed back wall

[ATTACH=full]40623[/ATTACH]

<blockquote data-quote="builder101" data-source="post: 131057" data-attributes="member: 12289">All the kind words help&#039;s keep the encouragement going, thanks.. I took a break from the scribing wing&#039;s today and cut out the floor for the cockpit and the back wall was scratchbuilt. I always remember the blue lights shining through the triangular shaped design in the back.&nbsp; I hope some of it is visible after I spray the cockpit glass a dark tint.. the glass right now in covered from dust after being dipped in future.&nbsp; I plan to run fiber to the cockpit and light behind the wall I built.&nbsp; Either styrene tube or brass run up along each side should light up the controls.&nbsp; Here is some pic&#039;s of the start of scratching out the cockpit. Thank&#039;s for for viewing. Once again I scribed the top and once again it did not turn out.. Back to sanding.Floor is cut to fit the bottom half.[ATTACH=full]40622[/ATTACH] Primed back wall [ATTACH=full]40623[/ATTACH]</blockquote>

[QUOTE="builder101, post: 131057, member: 12289"] All the kind words help's keep the encouragement going, thanks.. I took a break from the scribing wing's today and cut out the floor for the cockpit and the back wall was scratchbuilt. I always remember the blue lights shining through the triangular shaped design in the back. I hope some of it is visible after I spray the cockpit glass a dark tint.. the glass right now in covered from dust after being dipped in future. I plan to run fiber to the cockpit and light behind the wall I built. Either styrene tube or brass run up along each side should light up the controls. Here is some pic's of the start of scratching out the cockpit. Thank's for for viewing. Once again I scribed the top and once again it did not turn out.. Back to sanding. Floor is cut to fit the bottom half. [ATTACH=full]40622[/ATTACH] Primed back wall [ATTACH=full]40623[/ATTACH] [/QUOTE]

Verification