Reply to thread

Message

Thank's everyone.. I managed to do some modeling for the better part of the day today but progress is slow alot of scraping, sanding, measuring and scribing. I managed to get another wing just about complete I will need to sand out a few scratches find some small tubing for the top of the wing. Another thing that has been tough with this mod is finding the right tool to make all the square hole's.. I have tried heating brass, small computer repair screw drivers and using the dremel and a small bit.. I will figure something out.

Here is what I got down today and still need's minor details.

[ATTACH=full]40596[/ATTACH]

I scraped off a lot of the raised detail the bottom large part was tough with lots of sanding. I then cut more styrene I am using size 15 and 30 thickness for the deail that I have replaced. For anybody that plan's on builing this in the future.

[ATTACH=full]40597[/ATTACH]

<blockquote data-quote="builder101" data-source="post: 130960" data-attributes="member: 12289">Thank&#039;s everyone.. I managed to do some modeling for the better part of the day today but progress is slow alot of scraping, sanding, measuring and scribing. I managed to get another wing just about complete I will need to sand out a few scratches find some small tubing for the top of the wing.&nbsp; Another thing that has been tough with this mod is finding the right tool to make all the square hole&#039;s.. I have tried heating brass, small computer repair screw drivers and using the dremel and a small bit.. I will figure something out.&nbsp;&nbsp; Here is what I got down today and still need&#039;s minor details.&nbsp; [ATTACH=full]40596[/ATTACH]I scraped off a lot of the raised detail the bottom large part was tough with lots of sanding.&nbsp; I then cut more styrene I am using size 15 and 30 thickness for the deail that I have replaced.&nbsp; For anybody that plan&#039;s on builing this in the future. [ATTACH=full]40597[/ATTACH]</blockquote>

[QUOTE="builder101, post: 130960, member: 12289"] Thank's everyone.. I managed to do some modeling for the better part of the day today but progress is slow alot of scraping, sanding, measuring and scribing. I managed to get another wing just about complete I will need to sand out a few scratches find some small tubing for the top of the wing. Another thing that has been tough with this mod is finding the right tool to make all the square hole's.. I have tried heating brass, small computer repair screw drivers and using the dremel and a small bit.. I will figure something out. Here is what I got down today and still need's minor details. [ATTACH=full]40596[/ATTACH] I scraped off a lot of the raised detail the bottom large part was tough with lots of sanding. I then cut more styrene I am using size 15 and 30 thickness for the deail that I have replaced. For anybody that plan's on builing this in the future. [ATTACH=full]40597[/ATTACH] [/QUOTE]

Verification