The bottom hull has to fit or fold into the bottom

of the top hull, to do this i made sure to cut lines

on the opposite side of the lower hull.these lines would not show

that were cut, but would allow for the plastic to fold and

at the same time leave a seamless joint, as the break

lines are on the opposite side. The key is to to cut them

just enough to fold but not snap.Before any folding could be done

this little shape you see in the 2nd pic had to be removed.

[ATTACH=full]8691[/ATTACH]

[ATTACH=full]8692[/ATTACH]

[ATTACH=full]8693[/ATTACH]

[ATTACH=full]8694[/ATTACH]

[ATTACH=full]8695[/ATTACH]

[ATTACH=full]8696[/ATTACH]

[ATTACH=full]8697[/ATTACH]

Forgot to mention the break lines are filled with CA glue

after it is fitted properly into the top hull.