eh up all,here is the next post for y'all,

first off here are some other images where i left off,i started to put the guns together but i left the canopy off for easy access to flipping the model over to work on the bottom.

[ATTACH=full]75563[/ATTACH]

one thing i didn't mention was that i drilled out the gun barrels,which was a pain cos all it wanted to do was split the 2 halves apart.

[ATTACH=full]75564[/ATTACH]

next up was to put the bottom half of the modell on but as i had a look with a dry fit i noticed with all the fibre optics running underneath the seats it didn't fit no more.

before

[ATTACH=full]75565[/ATTACH]

after a little milliput fine and some sanding.

[ATTACH=full]75566[/ATTACH]

at the back it was worse i couldn't filler it or the air brakes wouldn't work.

[ATTACH=full]75567[/ATTACH]

and with 2 little cut pieces of half mm styrene i covered over the gaps.

[ATTACH=full]75568[/ATTACH]

and finally it gave me a horrible gap where the engine sat so that needed a little touch up also.

http://[http://i1173.photobucket.com/albums/r596/peza5/GEDC2130.jpg/img]

well that was it for the model for abit so i could concentrate on the base.i made myself i base using 1.5mm thick styrene and scribed some panel lines into it.

[ATTACH=full]75569[/ATTACH]

sorry for the wobble must of had afew by then :P

here you can see the bottom,note the kids bendy for the cables to run through.

[ATTACH=full]75570[/ATTACH]

next up i preshaded the top with some tamiya iron grey(love this colour for the cockpit also).

[ATTACH=full]75571[/ATTACH]

then a coat of paint on top of that. i also black glossed the sides

[ATTACH=full]75572[/ATTACH]

well thats it for this on again hope you like cheers for lookin....peza ;D