My first OSL

Palantirion

Member
Joined
Sep 1, 2022
Messages
15
This was a cheap resin kit from eBay, roughly 1/12 scale, hollow cast with no back. I used styrene to make the back plate, otherwise not much prep but sanding and re-boring the hole for the support rod. Most of the paint is drybrushing over a black primer, with some stippling and washes also. I have an airbrush, which would have been a better choice for the middle orange tones, but part of the purpose of this project was to work on new drybrushing techniques. I look forward to your feedback.

22,09-12, Slave Leia in carbonite (1).jpg
22,09-12, Slave Leia in carbonite (2).jpg
22,09-12, Slave Leia in carbonite (3).jpg
22,10-25, Slave Leia in carbonite (1).jpg
22,10-25, Slave Leia in carbonite (2).jpg
 
89ITc.gif


That's cool , but I think you need to restore some shadow on the shade side of that lower texture . Up to the peaks of those folds .
 
That's cool , but I think you need to restore some shadow on the shade side of that lower texture . Up to the peaks of those folds .
-Thanks, I was actually wondering about exactly that! I may hit it with a colored LED around the upper section and see how the light falls, where shadow cores are, etc. and use that to refine the shadows.
 

Latest posts

Back
Top