Here are a few pics of what I finihsed yesterday and this evening...

There are two harnesses labelled "M" for connecting the saucer board to the single 5MM flasher LEDm on each side of the saucer at the 3 and 9 o'clock positions. The LED sits sideways between the holes top and bottom where you insert the plastic domes for the flashing formation lights. As is, the LED is bright enough but it's not pointed directly up or down to get the most illumination shining thru the plastic inserts so... I cut off the LED on each harness and spliced in two clear 2mm lighthouse LEDs wired in parallel purchased from Modeman Tom's website, Modeler's Brand Hobby Supplies. 

Here's the link to his site:

http://modelersbrand.com/

The board is providing 5V so no resistors are needed.

These LED's have long round narrow flat-topped necks that are the perfect size to fit thru the upper dome hole; just drill or route out a matching diameter sized cavity in the red and green domes provided in the lighting kit and insert the LED up thru the hull and cement into the plastic dome. For the lower flasher you would drill a matching cavity partway into the smaller clear part and then insert the kit part thru the hull in the lower saucer.

Anyway, in this pic you can see the lighting kit harness on top and my retro-fitted harness below. I now have separate dedicated flashers for each dome light top and bottom on each side:

[ATTACH=full]47620[/ATTACH]

Here are the shuttle bay walls and floor. Only the Galileo shuttle, back wall and floor have been decalled at this point:

[ATTACH=full]47621[/ATTACH]

The back wall:

[ATTACH=full]47622[/ATTACH]

The shuttle:

[ATTACH=full]47623[/ATTACH]

Tomorrow I should be able to finish the wall decaling and assemble the bay.