Cheers J . Yes , I did add the armour on the side of the head as ( you'll probably already know ) there's a nasty seam line down the entire part . As for the "neat" bend , I must admit , it was more by luck than judgement ! I just secured the piece of styrene sheet at the top and made sure the ( liquid) cement  was good and set before I bent the piece downward and into position , adding more cement as I went along . It was just a matter of taking it nice and slow . When it was completely dry , I just gave it a rub-down with a sanding pad to make sure it was nice and smooth . The AT-ST is a nice kit , that just needs a little bit of attention to bring out it's best . I wish I'd picked up a couple more when I had the chance , as I'd like to build it again !