Reply to thread

Decided to jump around a bit and worked on the rear heat sink

a bit. The part from the kit is not bad but has some issues. The

fins are a little rounded over on the edges so i sanded them flat,

and at the ends they have this wonky widening that goes on. I

went ahead and sanded that wonky wideness away.You can see

in the picture the bank on the top and the wideness that comes

with the kit part "AS IS," and the correction on the bank bellow.

[ATTACH=full]20859[/ATTACH]


The fins also have a strange angle to them on the top,

so i marked a line and straightened them out making

them much more 90 deg.

[ATTACH=full]20860[/ATTACH]


I also noticed on the studio model on the lower hull the

little inlets looked open so I opened them up on my model

kit as well. Not sure how deep it should run hollow, i may extend

the channel back so you dont see all the way in later on.

[ATTACH=full]20861[/ATTACH]


I also started marking out some panel lines on the

top hull they are scribed I just don't have a picture yet.....

next update. ;D

[ATTACH=full]20862[/ATTACH]


Back
Top