Thanks peza

......right, back on to the MPC Falcon.

It really has been a while (apart from finishing that foot) since I really paid any attention to it

There were areas that were a bit rough, so I've went over them again.

I attached the cockpit tube,.....only to discover that it was pointing upwards, so a bit of heat was applied to the hull to bend the hull level

[ATTACH=full]53599[/ATTACH]

[ATTACH=full]53600[/ATTACH]

While I was at it I removed a couple of the moulded pipes & replaced them with wire:

[ATTACH=full]53601[/ATTACH]

You cant really see here but I cut 3/4 of the docking tubes along where they join the hull & put spacers in to make the walkway look slightly taller:

[ATTACH=full]53602[/ATTACH]

Thanks for looking guys

John