Scrubbed parts in warm soapy water with a soft scrub brush:

[ATTACH=full]95654[/ATTACH]

Galileo Shuttle - WIP 010 by Steve J, on Flickr

Parts scrubbed and rinsed in another bucket or in the faucet spray. That should take care of any remaining mold release:

[ATTACH=full]95655[/ATTACH]

Galileo Shuttle - WIP 011 by Steve J, on Flickr

Parts laid on paper towels to dry:

[ATTACH=full]95656[/ATTACH]

Galileo Shuttle - WIP 012 by Steve J, on Flickr

First group of the interior parts are laid on newspaper while the exterior Galileo shuttle parts are washed and drying on the toweling:

[ATTACH=full]95657[/ATTACH]

Galileo Shuttle - WIP 013 by Steve J, on Flickr

Parts for the shuttle kit are laid out on the newspaper to finish drying:

[ATTACH=full]95658[/ATTACH]

Galileo Shuttle - WIP 014 by Steve J, on Flickr

All parts for the interior and exterior together laid out and drying.

Only the clear parts are not washed:

[ATTACH=full]95659[/ATTACH]

Galileo Shuttle - WIP 015 by Steve J, on Flickr

Next I'll prime, that is, once the temp gets over 65 degrees or so with the garage door open. Been below 50 here today.

I think light grey primer would do well. Then I'll play with the bottle paints.