Re: Enterprise D - from "Generations" - UPDATED 8/2/12

Finally gathered up enough steam to get back onto this after hitting the wall, just needed to forget about complex masking etc and just stick some plastic together for once! So, after a “cleansing” Batmobile and Bat-Pod, I got back to masking the lower secondary hull. Not finished yet, still got the undersides of the pylons to go over

Then it was back to mapping the upper saucer main pattern

Decided to change tactics with masking the saucer. I'm reversing the order that the lighter colours are going to be sprayed so rather than masking off the lightest layer and laying down the darker buff/tan over the top, the darker colour has been sprayed first. The appropriate masks will be cut and layed down, then the lighter colour will go down. This will make it a lot easier to “sync” the patterns when physically putting on the masks, and reduce the risk of mis-positioning the smaller ones (which was a problem on the secondary hull and nacelles)

So thats where i'm at right now, gonna be a one trick pony for a while with all this masking but I'll get there in the end!

Cheers for the good comments guys, thanks for following along

Soong