Reply to thread

Hi everyone, today spent  marking out the bricks and putting filler on the the plain walls. Used normal wall filler with a little addition of pva glue to assist in  holding.

[ATTACH=full]128969[/ATTACH]

The base has been altered by 5mm  to take a line of stone sets.


[ATTACH=full]128967[/ATTACH]

This will be glued on later, leaving off now so I can get the doors and side frames in.


[ATTACH=full]128968[/ATTACH]

I dry brushed the brick faces with a thinned Tamiya grey filler , used Real colour thinners by AK. Worked far better than IPA .This will harden and seal the the foam  so less brick colour will be absorbed.


[ATTACH=full]128970[/ATTACH]


Siad filler , cheap DIY shop brand. Once dry some sanding with a fine paper , 600 grit stuck onto a coffee stirrer seems to work.


Thanks for following and looking in. John.


Back
Top