Reply to thread

Message

Good day.
Had a bit of fun installing the lower jaw to the skull. This piece is so awkward that finding a good way to support it while the glue set was very difficult. Ended up just holding it in place.
Also glued together the parts of the upper spine and neck. These went together fairly straight forward.
Last night I mated the skull to the upper spine and left it to dry overnight.

[ATTACH=full]84002[/ATTACH]

I've also been working on the legs.
One issue was that the placement of the rear toe was not correct and had to modify the part and place it in it's proper location.
The placement of the lesser toe was straight forward.

[ATTACH=full]84003[/ATTACH]

Cannot go any farther with the left leg till the pelvic bones are installed and the spine supported into position.
Started working on the right foot.

Thank you for following.
Questions and comments welcome.

Jim

<blockquote data-quote="Papermodder" data-source="post: 200538" data-attributes="member: 12832">Good day.&nbsp;Had a bit of fun installing the lower jaw to the skull. This piece is so awkward that finding a good way to support it while the glue set was very difficult. Ended up just holding it in place.&nbsp;Also glued together the parts of the upper spine and neck. These went together fairly straight forward.Last night I mated the skull to the upper spine and left it to dry overnight.[ATTACH=full]84002[/ATTACH]I&#039;ve also been working on the legs. &nbsp;One issue was that the placement of the rear toe was not correct and had to modify the part and place it in it&#039;s proper location.&nbsp;The placement of the lesser toe was straight forward.[ATTACH=full]84003[/ATTACH]&nbsp;Cannot go any farther with the left leg till the pelvic bones are installed and the spine supported into position.Started working on the right foot.Thank you for following.Questions and comments welcome.&nbsp;Jim</blockquote>

[QUOTE="Papermodder, post: 200538, member: 12832"] Good day. Had a bit of fun installing the lower jaw to the skull. This piece is so awkward that finding a good way to support it while the glue set was very difficult. Ended up just holding it in place. Also glued together the parts of the upper spine and neck. These went together fairly straight forward. Last night I mated the skull to the upper spine and left it to dry overnight. [ATTACH=full]84002[/ATTACH] I've also been working on the legs. One issue was that the placement of the rear toe was not correct and had to modify the part and place it in it's proper location. The placement of the lesser toe was straight forward. [ATTACH=full]84003[/ATTACH] Cannot go any farther with the left leg till the pelvic bones are installed and the spine supported into position. Started working on the right foot. Thank you for following. Questions and comments welcome. Jim [/QUOTE]

Verification