Reply to thread

Put a blob of CA onto some surface (I use the inside of bottle caps) then with a very fine applicator (stretched sprue for example) get some from it and apply lightly over the contact points, and not on the mesh if you can avoid it.


It's what I did to glue the meshes on this guy (http://theironkeep.files.wordpress.com/2013/02/20130211_m113-tuga_0007.jpg) and worked fine but you need to be patient and may need to work one side at a time.


Also as the stretched sprue starts deforming just cut that bit and you get a instant clean applicator.


Back
Top