Ello,

So whats been happening, not much to be honest, zero hours in June and only 11 in July.

Think my mojo was lost.

Think i got it back

Lets see.

Thanks for the positive vibes dudes

On with the show

So after the detail panels were finished i had to get all the inner walls to the same stage

This is the main back support

[ATTACH=full]82800[/ATTACH]

Cut the outer rings

[ATTACH=full]82801[/ATTACH]

Group picture

[ATTACH=full]82802[/ATTACH]

Then started work on the small additional detail panel that i realised i would need to fill a void

[ATTACH=full]82803[/ATTACH]

X4

[ATTACH=full]82804[/ATTACH]

[ATTACH=full]82805[/ATTACH]

[ATTACH=full]82806[/ATTACH]

dry fit

[ATTACH=full]82807[/ATTACH]

Ready for primer

[ATTACH=full]82808[/ATTACH]

Made some small ones again to fill gaps and add depth and interest

[ATTACH=full]82809[/ATTACH]

Then it was time to move on to the nozzel internals

Started with small vector actuators

[ATTACH=full]82810[/ATTACH]

[ATTACH=full]82811[/ATTACH]

This is the vector thrust bulkhead made from a mouthwash two pack carry handle, separated and cleaned up, drilled to receive the actuators

[ATTACH=full]82812[/ATTACH]

[ATTACH=full]82813[/ATTACH]

Added T and U channel

[ATTACH=full]82814[/ATTACH]

And thats about it so far

Did manage to finish my little shuttle launch side project

[ATTACH=full]82815[/ATTACH]

[ATTACH=full]82816[/ATTACH]

[ATTACH=full]82817[/ATTACH]

Thats it for now kids

Take care

Gag