Ello Every Peeps,
Thank you for stopping by chaps,
Once again lots to show so lets get too it...........
Marked out, cut and finished another underside assembly
[ATTACH=full]68878[/ATTACH]
[ATTACH=full]68879[/ATTACH]
Added some tubing for rigidity
[ATTACH=full]68880[/ATTACH]
Drilled wiring holes in all the brace pieces
[ATTACH=full]68881[/ATTACH]
Re-assembled everything, this time gluing as i went
[ATTACH=full]68882[/ATTACH]
[ATTACH=full]68883[/ATTACH]
[ATTACH=full]68884[/ATTACH]
Taped in position
[ATTACH=full]68885[/ATTACH]
Started on the rear underside body
[ATTACH=full]68886[/ATTACH]
[ATTACH=full]68887[/ATTACH]
[ATTACH=full]68888[/ATTACH]
[ATTACH=full]68889[/ATTACH]
[ATTACH=full]68890[/ATTACH]
[ATTACH=full]68891[/ATTACH]
[ATTACH=full]68892[/ATTACH]
[ATTACH=full]68893[/ATTACH]
[ATTACH=full]68894[/ATTACH]
And in position
[ATTACH=full]68895[/ATTACH]
[ATTACH=full]68896[/ATTACH]
[ATTACH=full]68897[/ATTACH]
Then back to the main section
Some supports
[ATTACH=full]68898[/ATTACH]
Glued to a sheet of 1mm styrene sheet
[ATTACH=full]68899[/ATTACH]
Then wrapped around the spacers to achieve the correct shape
[ATTACH=full]68900[/ATTACH]
Then both sides are trimmed
[ATTACH=full]68901[/ATTACH]
Then more underside supports are added and the edge is finished to this support
[ATTACH=full]68902[/ATTACH]
[ATTACH=full]68903[/ATTACH]
Added a hole for the stand
[ATTACH=full]68904[/ATTACH]
Then some supports for the tapered transition piece
[ATTACH=full]68905[/ATTACH]
[ATTACH=full]68906[/ATTACH]
[ATTACH=full]68907[/ATTACH]
[ATTACH=full]68908[/ATTACH]
[ATTACH=full]68909[/ATTACH]
Then on to the front section
[ATTACH=full]68910[/ATTACH]
[ATTACH=full]68911[/ATTACH]
[ATTACH=full]68912[/ATTACH]
Added a spacer cover because it wasn't pretty but i can hide it later whats important is the basic shape
[ATTACH=full]68913[/ATTACH]
[ATTACH=full]68914[/ATTACH]
[ATTACH=full]68915[/ATTACH]
[ATTACH=full]68916[/ATTACH]
And thats about it for now
Still more to come
So stay tuned
Gagster out
